Tu veux un look badass sur ta board ? Change tes moteurs de position !



ça se passe ici :wink:

Hi, everyone, I am trying to design a gear drive gearbox.
This one can work for caliber trucks 180mm with 50XX or 63xx motors (8mm shaft) and ABEC11 83mm wheels.
I use a 1:2 Spiral Bevel Gears (Now using nylon, pom or aluminum will be used in the future.)
Everything goes smoothly it will sell 200 USD for one
Now I am waiting for my new gear (the picture is 3D printed)
Finally, I am sorry that my English is very bad.

Ouai j’ai vu ça, mais je trouve qu’il y a pas d’intérêt par rapport à une système à courroie, ou un direct Drive classique

Ouai j'ai vu ça, mais je trouve qu'il y a pas d'intérêt par rapport à une système à courroie, ou un direct Drive classique

par rapport a un système a courroie l’intérêt est visible instantanément.
apres ca fait des planches comme les evolve, pas possible les les poser à la verticale

Mettre deux gros moteur 6374 ou plus gros sur un Caliber II, perso j’y vois un intérêt mais y a ptet que moi :wink:

sympa comme innovation

C’est sympa ! En dual ça dois donner une sacrée gueule !!

Interesting !:grinning: y’a la meme chose dans une tete de meuleuse …

https://www.google.com/search?safe=off&biw=1280&bih=612&tbm=isch&sa=1&ei=3McpXYuIAo2G1fAPm5aTkAU&q=meuleuse+engrenage+pignon&oq=meuleuse+engrenage+pignon&gs_l=img.3...880.2509..2924...0.0..1.509.1565.0j4j1j1j0j1......0....1..gws-wiz-img.zELdSHvXZEg

1 « J'aime »